The cost per piece of metal 3D printing exceeds that of traditional processing

The cost per piece of metal 3D printing exceeds that of traditional processing. Meiguangsuzuo will bring new equipment to the 2025TCT

Antarctic bear 3D printing

The 2025 TCT Asia Exhibition will be held in Halls 7.1 & 8.1 of the National Exhibition and Convention Center (Shanghai) from March 17 to 19, 2025. Antarctic Bear will broadcast and report the exhibition continuously.

At this exhibition, Micron will bring two new heavyweight products to the show (booth number: 8C05), including the newly upgraded version of FF-M300S and DeskFab H1 desktop metal 3D printer.

Upgraded FF-M300S metal 3D printer

The new upgraded version of FF-M300S will make its debut at the exhibition. This revised and upgraded version of FF-M300S has a higher degree of integration and a smaller size, taking into account the balance between printing size and cost-effectiveness.

High efficiency Printing mass production/two-way powder spreading technology/improving printing accuracy and efficiency

●The independently developed LFPT (Light Following Powder Technology) subverts the efficiency boundary of traditional 3D printing technology

●Achieve finer layer thickness control and higher printing accuracy, saving up to 15 seconds per layer and increasing overall model processing time by 50%

●Stabilize printing quality and ensure the consistency and reliability of finished products. Bring revolutionary improvements to the mass production of metal parts

● M300 series is newly upgraded, and the supporting software is free

Industrial mass production saves money

Permanent filter element/intelligent monitoring reduces manual monitoring costs

●Permanent filter element working time exceeds 30,000 hours

●The device has its own camera to monitor the operation and printing at any time, reducing the cost of manual supervision

●It can work continuously for 7x24 hours, helping industrial production to achieve truly efficient and intelligent production

●Save 100 filter element costs, no replacement is safer

Years of first-line factory case verification

Helping thousands of industries upgrade their smart manufacturing/years of case verification

●More than 1,000 units of the entire series have been sold, with cooperative customers all over the world

●Massive parameter library for selection, making parts printing smarter

●The equipment runs stably and the after-sales service is worry-free

DeskFab H1 Desktop

DeskFab H1 desktop machine is a metal 3D printer with compact size, complete functions and easy operation. It can solve your budget and site problems, lower the operating threshold and make the machine highly efficient.

One-to-N intelligent collaboration, full coverage of teaching and scientific research

Simple operation/three-step printing/open parameter library

● The teaching software supports one-to-n and virtual simulation

●Self-developed software development for three-step printing, achieving zero-based 3D printing

● Massive parameter library provides options for you to choose from without paying for risks

● 6 versions have been iterated and are running stably

0.39㎡ Smaller than an oven

Permanent filter element/replaceable powder bin/electrical double reduction

●The permanent filter element works for more than 30,000 hours, and the filter element has “zero” cost

●Multiple machines with various materials to switch at will

●The forming chamber is small in size, and the gas consumption is about 1-1.5L/minute, which can save a huge amount of gas cost in long-term use.

●Permanent filter element, no need to replace, safe and secure

200g startup, multiple material switching

International cutting-edge/wide application range/remote monitoring

● One machine for multiple uses, multiple materials can be switched at will

●Supports printing without protective gas

●Supports at least 200g startup, no need to prepare multiple materials for printing